Arthroscopically assisted acromioclavicular joint reconstruction avoids the large incisions necessary with open reconstructions. This acromioclavicular joint reconstruction technique via the subacromial space does not violate the rotator interval or require screw removal. The patient is placed in a modified beach-chair position. The arthroscope is placed into the subacromial space, and a bursectomy is performed through a lateral subacromial portal. The coracoacromial ligament is released from the acromion with an electrocautery and an arthroscopic elevator. A nonabsorbable suture is passed through the coracoacromial ligament with a suture passer, and an arthroscopic suture grasper is used to deliver both ends of the suture out through the lateral portal. The coracoid is identified and isolated using a radiofrequency ablator placed through the anterior portal while visualizing through the lateral portal. A percutaneous shuttle device is passed through the skin superomedial to the coracoid. The shuttle is visualized entering superior to the coracoid and is passed just medial to the coracoid. Once the tip of the shuttle can be visualized in the recess inferior to the coracoid, the shuttle loop is advanced. A suture grasper is used to deliver both ends of the shuttle out through the anterior portal. A semitendinosus allograft is used to reconstruct the coracoclavicular ligament. A nonabsorbable suture is passed through both ends of the allograft. Three strands of nonabsorbable suture are braided together. The tendon and the braided suture are shuttled around the coracoid. At this point, both the braided suture and the allograft tendon enter the anterior portal, wrap around the coracoid base, and exit the anterior portal. A 3-cm incision is made over the distal clavicle. A hole is drilled through the clavicle with a 5-mm drill. A loop of 22-gauge wire is passed through the hole in the clavicle, and a looped suture is shuttled through the hole. A curved clamp is used to create a tunnel from the acromioclavicular joint, under the deltoid, to the anterior portal. The ends of the braided suture and the tendon sutures are grasped by the clamp and pulled out the acromioclavicular joint incision. The limbs of the braided suture and the tendon suture that pass medial to the coracoid are shuttled through the hole in the clavicle using the looped suture that was previously passed through the clavicle. The acromioclavicular joint is reduced by pushing down on the distal clavicle with a bone tamp while simultaneously lifting the acromion upward by superiorly loading the humerus at the elbow. Once the acromioclavicular joint is reduced or slightly over-reduced, the braided suture is tied down securely. The acromioclavicular joint should remain reduced even after the manual reduction maneuver is released. The semitendinosus allograft is tensioned around the distal end of the clavicle and sutured to itself with a nonabsorbable suture. The released coracoacromial ligament is retrieved from the clavicular incision and sutured to the distal clavicle and semitendinosus allograft. The incision is closed in standard fashion, and a sling is applied.
